Asbestos Tile Mitigation

Posted on

Asbestos Tile Mitigation, | Applying asbestos tile sealer is a good method to help control the spread of asbestos fibers in the air. You may be surprised to learn that more than one-third of homes built before 1978 have asbestos as a major part of their construction. Plaster or tiles containing asbestos are common throughout homes, schools, and businesses.

Asbestos Tile Mitigation

Asbestos has been in use for decades, and it has now become a health hazard. It is a naturally occurring mineral that is composed of aluminum, oxygen, phosphorus, silicon, and fluorine. It is a great insulator. Because it is so light and is capable of expanding, asbestos has the capability to form very long fibers that can be found in ceilings, flooring, and walls.

Asbestos fiber is actually the building block of ceilings tiles and wallpaper. When it gets wet, it becomes airborne. This is why it is important to properly seal these exposed areas with asbestos tile mitigation products.

When these fibers become wet, they absorb moisture and form clumps that are very difficult to get rid of. To get rid of the moisture, homeowners and construction workers should use asbestos tile sealer. Another way to stop these fibers from being moist is to seal up seams and cracks in the tile itself.

The first step in treating your home for asbestos tile mitigation is to locate the tiles. By following a simple guideline, you can ensure that your tiles will be properly treated before putting them in your home.

Before getting any asbestos tile sealer on the floor, first work to make sure all openings are blocked. If not, you might end up spreading the sealer in ways that are not intended.

The Appeal of Mesothelioma Lawsuit Statute of Limitations

After you have done this, carefully open up the tile, preferably with a dry cloth. Even if you have done this several times, you will need to pay special attention to the edges. You want to make sure that the area is dry and air tight.

You should also keep in mind that different sealing agents are going to need to be applied to the tiles differently. You might want to do this before or after you apply the sealer. In many cases, the sealer is completely absorbed into the material, but you may find it necessary to let it soak for a few minutes.

Remember that the absorbent material should be able to help suck up the sealer before it dries. You should never scrub the sealer away from the surface because this could weaken the surface in question.

After you have applied the asbestos tile sealer, it is important to wait a few days before going into the home to inspect for cracks or areas where the sealer may have leaked through. If you find any areas that might have a small leak, be sure to quickly fill them up with mortar and cover the problem with tile-grade sealer.

Remember that asbestos tile sealer is not something that you should apply over an existing seam or surface that might be compromised. It should only be used to help prevent the escape of fibers and moisture.

Applying asbestos tile sealer on top of an existing sealer can result in damage to the sealer. Before doing this, you should make sure that you have some type of adhesive that can put down the new sealer without causing more damage to the original sealer.

Leave a Reply

Your email address will not be published.